Document conventions - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - IEC 60870-5-101/104 Communication Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 19.04.2023

SSC600 and SSC600 SW IEC 60870-5-104 Communication Protocol Manual

A particular convention may not be used in this manual.

  • Abbreviations and acronyms are spelled out in the glossary. The glossary also contains definitions of important terms.
  • Menu paths are presented in bold.

    Select Main menu/Settings.

  • Parameter names are shown in italics

    The function can be enabled and disabled with the Operation setting.

  • Parameter values are indicated with quotation marks.

    The corresponding parameter values are "On" and "Off".

  • Input/output messages and monitored data names are shown in Courier font.

    When the function starts, the START output is set to TRUE.

  • This document assumes that the parameter setting visibility is "Advanced".