Using the WHMI - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 17.04.2023

SSC600 and SSC600 SW Engineering Manual

As secure communication is enabled by default, the WHMI must be accessed from a Web browser using the HTTPS protocol.

Tip: To establish a remote WHMI connection to the IED, contact the network administrator to check the company rules for IP and remote connections.

Note: Disable the Web browser proxy settings or make an exception to the proxy rules to allow the protection IED's WHMI connection, for example, by including the IED's IP address in Internet Options/ Connections/LAN Settings/Advanced/Exceptions.

For more information on the WHMI, see the operation manual.