Setting the IED IP address in a project - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 17.04.2023

SSC600 and SSC600 SW Engineering Manual
The IP address and subnet mask of the IED object in PCM600 must match the local / remote and rear port of the IED (physical IED) to which the PC is connected. The IP address of the IED can only be set via the WHMI or Parameter Setting tool in PCM600. The PC and IED need to be on the same subnet.
There are two alternatives to set the IP address of an IED object in PCM600.
  • On the first page of the wizard when including a new IED into a project.
  • In the IP address box of the IED's Object Properties dialog box.
Figure 1. Alternative 1: Setting the IP address on the first wizard page
Figure 2. Alternative 2: Setting the IP address in IED's Object Properties dialog box
Choosing between the two ways depends on when the IP address is set. Typing the IP address via the IED's Object Properties dialog box is possible at any time while entering it via the configuration wizard can only be done when adding the IED object.
  1. In the Plant Structure view, select the IED to which the IP address is to be entered.
  2. On the View menu, select Object Properties.
    Object Properties dialog box is opened.
  3. Type in the IP address to the IP Address row.