Mounting the device - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 17.04.2023

SSC600 and SSC600 SW Engineering Manual

The SSC600 provides kits for rack mounting in the chassis.

Figure 1. SSC600 product installation on rack location

Figure 2. The installation cabinet of SSC600

Use the 4 screw holes to mount the SSC600 on the rack.
CAUTION: The SSC600 can only be used in a standard equipment cabinet with a minimum of 2Us available. The equipment cabinet must satisfy two requirements:
1. The maximum size of the cooling hole on the top, left, right, front and back is no more than 5mm.
2. There is no limit on the size of the hole on the bottom.
The SSC600 has aluminum fins on the top of the unit as heat-sink. It can generate natural convection for better heat transmission. To have optimal thermal performance, leave 2U (88.9 mm) space above the unit.