Defining data set entries with the IEC 61850 Configuration tool - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 17.04.2023

SSC600 and SSC600 SW Engineering Manual
  1. Select the Data Sets tab.
  2. Right-click a data set and select Details to add data attributes.
    Figure 1. Adding data attributes
  3. In the data set entry window, select the data attribute to be contained in the data set.
    • Click Append selected to add the data attribute to the end of the data set.
    • Click Insert selected to add the data attribute above the selected row in the data set entries list.
    • To remove a data attribute from the data set, select the data attribute in the data set entries pane and click Removed selected.

    Reporting datasets can include status and measurement type of data. Also configuration and setting values can be added to datasets in case required.

    Note: Data set entries for vertical reporting are selected using the data object level, and entries for GOOSE using the data attribute or data object level.
    Note: The default data set for SMV sending is fixed and may not be modified.