Configuring SMV with the IEC 61850 Configuration tool - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI

After you have added all SMV senders (all 615 series relays or MUs) to the PCM600 project, you need to configure SSC600 to receive streams from all those devices using the IEC 61850 Configuration tool. You see all senders and receivers in the window when you select substation node in the Plant Structure.

Start the IEC 61850 Configuration tool.
Select Process Bus Communication in the drop-down box on the toolbar.

Figure 1. Selecting Process Bus Communication
The SMV sender and SMV receiver IEDs become visible. Edit the properties and addresses of the sampled value control block.

Figure 2. Changing the VLAN ID

Tip: Some switches do not support multicast filtering with VLAN value “0” because it means “no VLAN” and VLAN 1 has special purpose as management VLAN for switches. Recommended value for VLAN is 2...1001.

Note: Use a unique multicast address for each SVCB. The address range for sampled values multicast addresses is 01-0C-CD- 04-00-00...01-0C-CD-04-FF-FF.
Connect the SMV sender to the receivers.

Figure 3. IEC61850 Configuration and SMV Control selection for SSC600

Note: If the configuration is updated in a manner that affects the Conf.Rev value of SVCB, configurations of both SMV sender and all receivers must be rewritten from PCM600.
In PCM600, select Write to IED.