Adding symbols into a display page - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 17.04.2023

SSC600 and SSC600 SW Engineering Manual
  1. Prepare the body of the single-line diagram by locating symbols to the wanted positions on the display.
  2. Drag the apparatus or transformer symbols into a raster box.
  3. Drag the connection symbols into a raster box.
  4. Place the junction points.
    Do not connect two symbols directly to each other. Instead, add a junction between them.
  5. Use the X and Y coordinates in the Object Properties window to adjust the placement of symbols in the single-line diagram.
    Figure 1. Graphical Display Editor: adding single-line diagram symbols into a display page
    1 X and Y coordinates