Adding a measurand - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 17.04.2023

SSC600 and SSC600 SW Engineering Manual
  1. Drag a Measurand object into a raster box.
    Figure 1. Adding a measurand object to an WHMI view
  2. In the Objects Properties view, edit the name, unit and the number of decimals.
    Unit text specifies the default text used for the measurement's unit. If the Unit text is empty in the Graphical Display Editor, no unit is shown. If the Unit text is not empty, the unit in the IED is updated dynamically based on the signal it is connected to. The Scale factor parameter is not used.
    Tip: Uncheck the option Place Symbol at available space in the Graphical Display Editor menu to allocate more space for symbols near measurands.