Adding a busbar - Arc protection - Bay control and measurement - Motor protection - Transformer protection - 2 winding - Busbar differential protection (low impedance) - Feeder protection - Voltage regulation - Busbar protection (voltage and frequency) - Capacitor bank protection - Interconnection protection - Power management/Load shedding - Back-up protection - Engineering Manual - SSC600 Smart substation control and protection - 1.5 - IEC - ANSI - 17.04.2023

SSC600 and SSC600 SW Engineering Manual
  1. Add at least two Busbar Junction elements from the Symbol Library to the display page.
  2. Select the Busbar Junction and use the rotate command from the toolbar to ensure that the busbar ends to the margin.
  3. Add links between the busbar junctions.
    Figure 1. Graphical Display Editor: drawing a busbar and placing busbar junctions
    1 Busbar junction
    2 Rotate command
  4. Add a link between one busbar junction point and the corresponding symbol or junction point.
Note: Only horizontal busbars are supported by SSC600 WHMI.