Rack mounting of two narrow size relays - Arc protection - Auto synchronization - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Petersen Coil control - Grid automation - Busbar differential protection (high impedance) - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Transformer protection - 3 winding - Interconnection protection - Generator protection - Power management/Load shedding - Installation Manual - REX640 Protection and control - Relion Protection and Control - PCL4 - IEC - ANSI - 16.10.2024

REX640 Installation Manual
  1. Attach protection relays to a 7U rack plate with M6 screws.
  2. Tighten the M6 screws to 9 Nm ±5% (6.6381 ft-lb ±5%).
    Figure 1. Mounting of two narrow size relays to the rack plate
    image/svg+xml12
    1
    7U rack plate
    2
    M6 screws
  3. Mount protection relays and rack plate to a 19" rack.

    The rack plate can also be mounted to the rack before protection relays are attached to it.

  4. Tighten the screws.
Figure 2. Two rack mounted narrow size protection relays
image/svg+xml