All connections are made on the front of the case. No soldering is needed.
- Connect signal connector terminals.
- Connect compression type (X1 and X2) terminals for CTs/VTs.
- Connect the terminals on the communication module for IRIG-B.
- Connect the RTD inputs and mA outputs using shielded stranded cables and connect the cable shield to GND rail.
- Connect all the sensors of the same type to adjacent channels.
Note: The cable shield is to be earthed at only one end of the cable with RTD cable shield rail.
Note: Use fine wire in door mounting.
Note: See the technical manual for product-specific terminal diagrams.