Editing GOOSE control blocks in IEC 61850 Configuration - Arc protection - Auto synchronization - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Petersen Coil control - Grid automation - Busbar differential protection (high impedance) - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Transformer protection - 3 winding - Interconnection protection - Generator protection - Power management/Load shedding - IEC 61850 Engineering Guide - REX640 Protection and control - Relion Protection and Control - PCL6 - IEC - ANSI - 14.02.2023

REX640 IEC 61850 Engineering Guide

To edit GOOSE control blocks, IEC 61850 configuration engineering mode must be enabled from options.

Figure 1. Enabling IEC 61850 configuration engineering mode
image/svg+xml
  1. To open IEC 61850 Configuration, right-click an IED and select IEC 61850 Configuration.
    Figure 2. Opening IEC 61850 Configuration
    image/svg+xml
  2. On the toolbar, select GOOSE Communication from the drop-down menu.
    Figure 3. Editing GOOSE control blocks
    image/svg+xml

    Use the Data Sets tab for editing data sets for GOOSE control blocks and the GOOSE Controls tab for editing GOOSE control blocks.