Checking SMV data with WHMI's GOOSE and SMV Diagnostics pages - Arc protection - Auto synchronization - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Petersen Coil control - Grid automation - Busbar differential protection (high impedance) - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Transformer protection - 3 winding - Interconnection protection - Generator protection - Power management/Load shedding - IEC 61850 Engineering Guide - REX640 Protection and control - Relion Protection and Control - PCL6 - IEC - ANSI

REX640 IEC 61850 Engineering Guide
  1. On the SMV Receiving page, check the sampled values data that the relay subscribes from the Ethernet network.

    The left side of this page shows a list of devices that send SMV messages to the relay. These devices that publish data for the relay are defined in the relay configuration. The right side of the page shows the SMV data that the relay receives from the network. The data set consists of value and quality attributes. The received data has status indicators where green means all OK, yellow warning and red error.

    Figure 1. WHMI SMV Receiving page
  2. On the SMV Sending page, check the status of the relay's configured SMV control blocks and the values of the sent sampled value data.

    The left side of this page shows a list of the devices where the relay sends SMV messages. In the system there may be more devices, but these devices are according to relay configuration the ones subscribing the data from the relay. The right side of the page shows the SMV data the relay sends to the network. The sent data has status indicators where green means all OK, yellow warning and red error.

    Figure 2. WHMI SMV Sending page