Parameter Setting - Arc protection - Auto synchronization - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Petersen Coil control - Grid automation - Busbar differential protection (high impedance) - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Transformer protection - 3 winding - Interconnection protection - Generator protection - Power management/Load shedding - Engineering Manual - REX640 Protection and control - PCL6 - IEC - ANSI - 16.02.2023

REX640 Engineering Manual

Configuration and setting parameters can be changed with LHMI, WHMI or with the Parameter Setting tool in PCM600.

Note: Some parameters are only visible in the Parameter Setting tool and some only on the LHMI.

Note: The Write to IED command from PCM600 to the protection relay overwrites any parameter changes made with the HMI.

All parameters displayed in the parameter list can be sorted into two groups.