Mapping IED in PCM600 plant structure - Arc protection - Auto synchronization - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Petersen Coil control - Grid automation - Busbar differential protection (high impedance) - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Transformer protection - 3 winding - Interconnection protection - Generator protection - Power management/Load shedding - Engineering Manual - REX640 Protection and control - Relion Protection and Control - PCL6 - IEC - ANSI - 16.02.2023

REX640 Engineering Manual

To map the IED in the plant structure, drag a PCM600 IED from the Unassigned IEDs group onto an FPN IED in the substation.
IED mapping status is indicated visually in the plant structure.
To remove an IED mapping from the plant structure, drag a mapped FPN IED onto the Unassigned IEDs group.
The removed mapping is indicated visually in the plant structure. The PCM600 internal IED, with which the FPN IED was mapped, appears back in the Unassigned IEDs group if it is not mapped with any FPN IEDs.