Clearing and acknowledging - Arc protection - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Grid automation - Busbar differential protection (high impedance) - Line differential protection - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Interconnection protection - Generator protection - Power management/Load shedding - Operation Manual - REX615 Protection and control - PCL2 - IEC - ANSI - 14.05.2025

REX615 Operation Manual

The Clear button is used to reset, acknowledge or clear all messages and indications, including LEDs and latched outputs as well as registers and recordings. Press the Clear button to activate a selection menu, and select the wanted clearance or reset function. Events and alarms assigned to programmable LEDs are cleared with the Clear button as well.

  1. Press to activate the Clear view.
    Figure 1. Clear view
    image/svg+xml
  2. Select the item to be cleared with or .
  3. Press , change the value with or and press again.
    The item is now cleared.
  4. Repeat steps 2 and 3 to clear other items.
Tip: Use the button as a shortcut for clearing. If you keep the button pressed, after 3 seconds there is a yes/no confirmation to clear indications. If you continue to keep the button pressed for 3 more seconds, there is a yes/no confirmation to clear programmable LEDs and if you still keep the button pressed for 2 more seconds after this, there is a yes/no confirmation to clear all.