Changing the close delay mode - Arc protection - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Grid automation - Busbar differential protection (high impedance) - Line differential protection - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Interconnection protection - Generator protection - Power management/Load shedding - Operation Manual - REX615 Protection and control - PCL2 - IEC - ANSI - 01.04.2026

REX615 Operation Manual
  1. Select Main menu > Configuration > Control > LHMI > CB close delay mode and press .
  2. Select the delay mode with and .
  3. Press to confirm the selection.
Figure 1. Changing the close delay mode

Note: Use delayed control only in the local control mode.