Editing data sets in IEC 61850 Configuration - Arc protection - Bay control and measurement - Merging unit - Transformer protection - 2 winding - Feeder protection - Voltage regulation - Capacitor bank protection - Grid automation - Busbar differential protection (high impedance) - Line differential protection - Back-up protection - Motor protection - Busbar protection (voltage and frequency) - Interconnection protection - Generator protection - Power management/Load shedding - IEC 61850 Engineering Guide - REX615 Protection and control - PCL2 - IEC - ANSI

REX615 IEC 61850 Engineering Guide

To edit data sets, IEC 61850 configuration engineering mode must be enabled from options.

Figure 1. Enabling IEC 61850 configuration engineering mode
  1. To open IEC 61850 Configuration, right-click an IED and select IEC 61850 Configuration.
    Figure 2. Opening IEC 61850 Configuration
    image/svg+xml
  2. On the toolbar, select the communication mode for which data sets are managed.
    Figure 3. Selecting the type of the data sets to be edited
    image/svg+xml
  3. Manage data sets on the Data Sets tab.
    1. To add new data sets, right-click and select New.
    2. To delete data sets, select the data sets to be deleted, right-click and select Delete.
    3. To edit entries in a data set, select the data set and open Entries from Object Properties.
    Figure 4. Adding, deleting or editing a data set

    This opens a dialog box where entries can be added or removed.

    Figure 5. Editing data sets