Setting up IP addresses - Arc protection - Motor protection - Feeder protection - Back-up protection - Engineering Manual - REX610 Protection and control - 1.2.1 - IEC - ANSI - 03.05.2023

REX610 Engineering Manual

The IP address and the corresponding subnet mask can be set via LHMI for the rear Ethernet interface in the protection relay. Each Ethernet interface has a default factory IP address when the complete protection relay is delivered.

Set the IP address for the protection relay's rear port and the corresponding subnet mask via the LHMI path Configuration > Communication > Ethernet > Rear port.
Table 1. Default IP address for the rear port and the corresponding subnet mask
IP address Subnet mask
192.168.2.10 255.255.255.0