Default operation mode for generic control point - Arc protection - Merging unit - Motor protection - Application Manual - REM620 Motor Protection and Control - 2.0 FP1 IEC - IEC - 01.06.2023

REM620 Application Manual

Table 1. Default operation modes
Channel Signal name Value Pulse length
1 SG1 Enabled Pulsed 150 ms
2 SG2 Enabled Pulsed 150 ms
3 SG3 Enabled Pulsed 150 ms
4 SG4 Enabled Pulsed 150 ms
5 SG5 Enabled Pulsed 150 ms
6 SG6 Enabled Pulsed 150 ms
7 Off 1000 ms
8 Emergency Start Pulsed 150 ms
9 DR Trigger Pulsed 150 ms
10 Trip Lockout Reset Pulsed 150 ms
11 CB Block Bypass Toggle 1000 ms
12 Restart Inhibit Toggle 1000 ms
13 Off 1000 ms
14 Off 1000 ms
15 Off 1000 ms
16 Emergency Stop Pulsed 150 ms
Grey cells indicate different default settings.