Writing parameters to an IED - Software products - Getting Started Guide - PCM600 Protection and Control IED Manager - 2.13 - IEC - ANSI - 29.06.2023

PCM600 Getting Started Guide
In Parameter Setting, parameters can be written to an IED.
  1. In Plant Structure, select an IED.
  2. On the menu bar, click IED and select Write parameters to IED.
  3. In the Write Parameters to IED window, select the Parameter range and the Parameter options.
  4. Select Read back check box, if the parameters must be read back after writing.
  5. Click OK.
    Note: In Parameter Setting, only the parameters are written to the IED, not the whole configuration.
If the writing of a single parameter fails, an error message is displayed. Continue by choosing one of the given options.
  • Click Retry to write the parameter again.
  • Click Skip to skip the parameter.
  • Click Skip all to continue the writing of parameters and skip automatically the possible parameters that fail.
  • Click Cancel to end the writing procedure.
    Note: Locked parameters
    are not written to IED before unlocking them. The locked parameters must first be unlocked
    by right-clicking the PC value field and selecting Unlock parameter.