Sending and receiving data - Software products - Getting Started Guide - PCM600 Protection and Control IED Manager - 2.13 - IEC - ANSI - 04.07.2023

PCM600 Getting Started Guide
In the Data Sets, GOOSE Controls, Report Controls and Sampled Value Controls tabs, it is possible to configure the sending or receiving of data. A check mark in the matrix means that the data on the row is sent to or received by the client in the column.
  • To send or receive data, select a check box in the mapping matrix.
  • To send data to all receivers, right-click the data to be sent and select Send to All.
  • To receive all data, right-click a receiver and select Receive All.
  • To receive the same data as another IED, right-click a receiver, select Receive Same Data As and select an access point from the pop-up menu.
    Note: When sending or receiving a data set, the corresponding control block is created automatically on the sending IED if it does not exist yet. When sending or receiving GOOSE or sampled value data, the inputs corresponding to the sent or received data set are created automatically on the receiving IED.