With the M2M Gateway ARM600 Patrol application it is possible to write new configurations in batch to many RIO600 devices connected to one or many Arctic devices. The RIO600 configurations to be written to RIO600 devices has to first be exported from PCM600.
Select the Arctic devices to be managed.
Verify the Selected devices shown on the upper part of the pane.
On the left pane under the Arctic Patrol menu, select Management.
In the management actions list, verify that the correct devices are selected and select RIO600 Configuration Update under Tools.
In the management actions list, select RIO600 Configuration Update and click Next.
Figure 1. Selecting RIO600 configuration update
Click Browse to select the firmware file and then click Upload file. The uploaded configuration packages appear in the drop-down list.
CAUTION: RIO600 configuration packages are exported from PCM600.
Select an uploaded RIO600 configuration package file from the Choose File drop-down list and click Next.
Figure 2. Selecting RIO600 configuration package
ARM600 asset management tries to automatically associate uploaded configurations to the found devices. However, if this is not possible, create the association manually.
Select a configuration from the left side under Configurations.
Select a RIO600 device from the right side under Devices.
Click the blue arrow to create the association.
Figure 3. Creating associations manually
CAUTION: Ensure that each configuration is compatible and intended for the selected RIO600 device.
Click Run update on selected devices to add the task to the batch.
Figure 4. Updating RIO600 configuration
Note: Ensure that the RIO600 device has a firmware version compatible with the uploaded configuration.